I see in the CFX V10 manual
We advise to have the activator and aux switches wired with a dedicated negative wire that returns
to the low power ground pad as depicted above. Make sure you twist / braid the activator, auxiliary
and negative (gnd) wires together to avoid the transformer & induction effect from the LED power
However, the wiring diagram I am using shows the switch negative going to the board negative.
Question: For a neopixel build with the following components and options, should the switches be wired to the low power ground or to the board negative?
Activator Switch - momentary with LED ring where LED is desired to be left unlit at all times
Auxiliary Switch - momentary no LED
No Recharge Port
11-pin Hilt Side PCB
What are the benefits/disadvantages of each option?