fiduciary
« previous next »
[1] Go Down

Author Topic: Master Replica Force FX Darth Vader Lightsaber sticky rubber  (Read 63 times)

0 Members and 1 Guest are viewing this topic.

Offline Jben04

  • No Force
  • *
  • Posts: 2
  • Um...Hello?
Master Replica Force FX Darth Vader Lightsaber sticky rubber
« on: February 10, 2021, 02:27:17 PM »
Just discovered that my Darth Vader Fx lightsaber's hilt rubber has become tacky.
 Any recommendations on how to deal with this?..
 I'm not sure if its plastic covered by rubber,, if so then couldn't i just rub off the rubber coating?
Logged

Offline Darth Brooks

  • Experienced Force User
  • ****
  • Posts: 396
  • Um...Hello?
Re: Master Replica Force FX Darth Vader Lightsaber sticky rubber
« Reply #1 on: February 11, 2021, 03:53:06 PM »
Wet wash rag... dawn dish soap scrub them. It'll work believe it or not.

I used to have a 2002 Anakin AOTC MR FX and those rubber grips got all sticky and nasty and that's all I did. (Took a while of scrubbing) but they were like new.

It's just old hand oils and such that gets absorbed by the grips.
Logged

Offline Jben04

  • No Force
  • *
  • Posts: 2
  • Um...Hello?
Re: Master Replica Force FX Darth Vader Lightsaber sticky rubber
« Reply #2 on: February 12, 2021, 06:59:06 AM »
Thanks for the info,, ended up using "goo gone" worked like a charm.. now i need to go check all my .45 scaled replicas,, not looking forward to it.,
Logged
[1] Go Up
« previous next »