fiduciary

Author Topic: Help wiring biscotte V4  (Read 385 times)

0 Members and 1 Guest are viewing this topic.

Offline Master Shaftner

  • No Force
  • *
  • Posts: 22
  • The green blade ventures forth
Help wiring biscotte V4
« on: January 30, 2018, 07:16:03 PM »
So this is my first ground up install and I need some help.

Iím using a single red diode LED from ultrasabers, an ultrasabers buck puck, a non illuminated AV switch, Nano biscotte v4 with a TCSS wiring harness, LED ran crystal chamber, speaker, running on an 18650.

I canít seem to get the xxx wiring correct and I canít find anything online similar... PLEASE help me.
Just a guy looking to duel

Offline erv

  • Plecter Labs Inc. "Keeper of the Buttered Toast"
  • Manufacturer
  • Master Force User
  • *
  • Posts: 4201
  • Formerly known as Irvin PLECTER
    • Plecter Labs - Props Electronics
Re: Help wiring biscotte V4
« Reply #1 on: January 30, 2018, 09:17:21 PM »
The buckpuck gets wired in place of the led on the nb (between L- and vBat). The led is wired to the output of the buckpuck

Offline Master Shaftner

  • No Force
  • *
  • Posts: 22
  • The green blade ventures forth
Re: Help wiring biscotte V4
« Reply #2 on: January 31, 2018, 10:52:24 AM »
Thank you!
Just a guy looking to duel

Offline QUI-GON JINN

  • Also known as Jay-gon Jinn!
  • JEDI/ALLIANCE Master MODERATOR
  • Master Force User
  • **
  • Posts: 8380
  • Your focus determines your reality
Re: Help wiring biscotte V4
« Reply #3 on: January 31, 2018, 02:29:17 PM »
FYI, Buck pucks typically will not work with the NB boards as the puck requires at least 5 volts to operate. Also,  this may seem like a dumb question,  but why is there a resistor on the negative lead coming from the battery pack?


Offline erv

  • Plecter Labs Inc. "Keeper of the Buttered Toast"
  • Manufacturer
  • Master Force User
  • *
  • Posts: 4201
  • Formerly known as Irvin PLECTER
    • Plecter Labs - Props Electronics
Re: Help wiring biscotte V4
« Reply #4 on: January 31, 2018, 11:48:14 PM »
FYI, Buck pucks typically will not work with the NB boards as the puck requires at least 5 volts to operate.

warning, buckpucks became a generic naming for external current regulators, and some people use them with success in place of the resistors. But you are probably right regarding buckpuck from buckpucks and 5V, I forgot this.