fiduciary

Author Topic: Bending blade material- thin wall tccs blades  (Read 1458 times)

0 Members and 1 Guest are viewing this topic.

Offline darthgrant

  • No Force
  • *
  • Posts: 35
  • Um...Hello?
Bending blade material- thin wall tccs blades
« on: September 10, 2017, 09:52:36 AM »
So..... I'm needing to bend/shape a 1 in thin walled tccs blade.  Has anyone else done this?  Thoughts?

Offline livebyhonor

  • Force User
  • ***
  • Posts: 150
Re: Bending blade material- thin wall tccs blades
« Reply #1 on: October 14, 2017, 08:20:43 PM »
I have tried but with minimal success. Only thing I have tried though is heat with the heat gun. It's a very fine temperature line from bendable to burned and melted. Perhaps if you had a controlled temperature box to find that sweet spot. Another possibility may be a chemical that will soften Polly blades forva short time.