fiduciary

Author Topic: TeensySaber Software Discussion  (Read 20149 times)

0 Members and 2 Guests are viewing this topic.

Offline profezzorn

  • Mining Colony Members
  • Master Force User
  • *
  • Posts: 874
  • May the source be with you.
    • Hubbe's Corner
Re: TeensySaber Software Discussion
« Reply #390 on: November 13, 2018, 09:56:48 PM »
hey, I'm new to this whole proffieboard discussion, and my linux computer isn't recognizing the Proffieboard, so I can't upload anything to it. The link above on the GitHub site gave Linux instructions, but I was unable to figure out what they meant(it's been a few years since I touched a Linux OS.) Any chance someone could tell me in detail what to do?

Open up a shell/xterm/gterm/console whatever it's called in your linux dist.

Cut-n-paste the following two commands:
Code: [Select]
cd ~/.arduino15/packages/profezzorn/hardware/stm32l4/*/drivers/linux/
sudo cp *.rules /etc/udev/rules.d

You'll need to enter the root password when it asks you to.
If you don't have sudo installed, you'll need to run "su", enter the password and then run "cp *.rules /etc/udev/rules.d" after you are root.

Then restart the computer.