I do apologize for not covering this officially and sooner but I wanted to get a hilt
in hand first and have not yet been able to do that.
However since some members lately signed up for my chassis kit and did not realize that
in its current form may not fit properly I need to clarify things for everyone.
I have mentioned it elsewhere but we only touched on it briefly but as it has been said
the parks 2.0 is narrower in the bottom shell making my current chassis just a few
millimeters to large for the bottom half.
Also because of the threading there is less room length wise in the bottom.
I do have a 2.0 specific chassis in the works but may be waiting until I get one of the
2.0 hilts in hand to verify sizes and fitment before producing them because I'm not
sure if I want to do just the 1/2 chassis that will utilize parks new inner threaded top
end adapter included with the hilt or if I want to replace it with my own set-up like
I currently make.
Much of that will be determined by the shell integrity and if the threading need to be
replaced or omitted for other attachments.
Ideally I will do both but... and have a full replacement unit like my current chassis
as well as a 1/2 unit for a more "dueling" single cell NB CS chassis.
Again I'd prefer to have it in hand until I do any actual production for it.For the other Replicas like Romans or the Stainless steel version and possibly another
replicas form one or more guild members those will all work with my chassis just
as a normal vintage would.
Feel free to ask questions and If you would like to be notified of these kits once they
are ready please post your interest here as well.
Thank you for your continued interest in my graflex products and enthusiasm for fx-sabers
Layout Rendering for FX-SABERS 2.0 Graflex Chassis kitThe inquiry/interest list for Chassis Kits
32.The Force Is Strong