fiduciary

Author Topic: Question about chassis for my lightsaber (updated with pictures)  (Read 1084 times)

0 Members and 1 Guest are viewing this topic.

Offline Zephyr37

  • Force User
  • ***
  • Posts: 178
Hi Folks!

I have a lightsaber with a prizm 4 in it. I was wondering if it were possible to have my saber, given the dimension and choke in middle, have a chassis where it has a prizm 5 plus a removable battery on it. No re charge port needed, but port for RICE strongly preferred. Currently, as you can see in pictures, it has a chassis with prizm board, re charge port inside, and non removeable battery in choke. If it is possible, can you direct me to a sabersmith who would be able to do it? Thank you.







« Last Edit: October 23, 2017, 10:45:33 AM by Zephyr37 »

Offline Zephyr37

  • Force User
  • ***
  • Posts: 178
Re: Question about chassis for my lightsaber (updated with pictures)
« Reply #1 on: October 23, 2017, 10:46:27 AM »
Bump with updated pictures

Offline jbkuma

  • Mining Colony Members
  • Master Force User
  • *
  • Posts: 980
  • Pixels, everywhere.
    • Mad Science Workshoppe
Re: Question about chassis for my lightsaber (updated with pictures)
« Reply #2 on: October 24, 2017, 06:42:59 AM »
You should be able to 3D model something that will work. I think you should be able to keep a charge and rice port if you wanted, as well.  I integrated a JST connector into the chassis of a recent (non-saber) prop and that worked out rather nicely.

 

retrousse