Hello one and all,
It certainly has been a stupidly long-time since I was on this site but for many a good reason. Today I'm finally taking steps towards wiring a custom saber I've been mulling over for nearly 2 years, I however have a few problems.
Namely I'm hoping to get some advice/review of what will be my wiring setup so I don't futz this up, I am out of practice, but hope I've figured this out well enough.
My wiring setup is as follows:
I have a Tri-cree WWR, with the Red being my FOC, wired to a battery-holder for a 18650 lith-ion, I was thinking to use both White LEDS in this saber I was going to wire their positives to a .5 ohm resistor, leaving the red without one if that is both the safest and efficient/light brightness retaining setup.
I also have no clear idea what is the best way to wire these kind of switches pictured below for use as my power and Aux, and was hoping someone could shed some light.
If I left any crucial details out be sure to ask, and thanks in advance for any help I get.
May The Force Be With You.