FX-Sabers.com
The S.A.B.E.R. GUILD: Saber Manufacturers => Sith Planet => Topic started by: Scottm2815 on December 28, 2016, 01:43:23 AM
-
Anyone else had this issue where the metal on the grip section of the 2.0 appears to be bubbling?
I have photos but not sure how to upload them. Is there anything I can do about this as I'm worried it will spread further :(
-
To post photos on the forums, read over this:
Got a Question about how the forums work? Read this! (https://www.fx-sabers.com/forum/index.php?topic=3725.0)
and this:
How to make your Pictures clickable. (https://www.fx-sabers.com/forum/index.php?topic=11435.0)
As far as the bubbling on the grip section goes, it is likely the plating on the part coming off. There may be no way to fix it, sorry.
-
Thank you Qui Gon,
Basically sounds like it's buggered then :(
Any ideas why this would happen? My other Graflex is fine and is stored in the same cupboard