Hey Guys,
please forgive me if this was already discussed. I am working on my 4th NB V4 install with Neopixel blade config. Everything was bench tested and works fine. The Board "wakes up" and works flawlessly via momentary switch when no Blade is attached. When the board is active, I can attach the Blade and still everything is fine. I can turn the saber on/off and have all functions as intended. No issues whatsoever.
However when the board goes into deepsleep mode, I have to remove the blade in order to activate the NB again. I have the correct resistor on the data line and have tried different sizes of capacitors on the powerlines.
I am a little stumped as this Problem never occured previously.... any idea??