1" Blade Stock & Kr Sabers

[deviltronix]

Does anyone know where I can get a 1" blade stock that fits KR saber hilts? I Tried TCSS stock and diameter is too large.
Normally i'd sand a clear but for this Neopixel build I want to use Trans-White blade and I'd rather not sand it.

Thanks for help!

[I am a Skywalker]

Hi deviltronix,
Sorry for the delayed response, haven't had a proper look around the forum for a while. I haven't really looked much into KR hilts specifically but I will put a link to a customisable 1" heavy grade dueling blade, you might also want to check out KR's facebook page and see if they can suggest anything. Sorry I can't help you any more than that but I hope you manage to find something
HEAVY GRADE 1" Dueling Blade - Vader's Vault

[ABQThor]

If a blade is too large for the hilt that's actually a good thing because it helps with a stronger friction Bond. Now obviously doesn't fit right now but if you can measure how far down the latest supposed to be then Market off with say painters tape on the blade then sand that small portion until it will go into the blade holder. you'll have a tight fit and success