I'm not sure why I'm having this issue but whenever I change values in my configuration files, the changes do not seem to take effect, at least for the led current values. As a test, I even set my main channel value to the main blade very low (150) and it was still as bright as ever. The card is formatted correctly in FAT32, sound fonts are loading up beautifully but I'm unable to properly control my current output and any FoC effect causes my battery pack protection circuit to trip.
Any help? Here's a copy of the config just in case. I'm using CFv9. I've got two LEDs hooked in series for the main blade and a white LED hooked to FoC pad 1. The FoC LED is connected to a 3.3 ohm resistor.
// CFV9 Config
wakeup=1
led=0,0,0,900
fled=0,0,350,700
lled=0,0,350,700
scolor=16
focmix=0000
randc=0
blastp=0
random=3
pom=0
pof=0
magic=0
saberlock=0
tridenton=0
tridentoff=0
tridentm=0000
tridentfx=0
tridentflk=0
tridentquick=0
resume=0
blastm=0
randb=3
shmrd=75
shmrp=6
shmrr=12
shmr%=50,80
focd=100
focp=10
focr=14
foc%=60,99
focl=1
focb=1
focf1=1
focf2=1
focf3=0
shft=0
spshft=0
dyshft=0
qon=0
qoff=0
fade=0
flks=3
flkd=25
flkon=1
flkoff=1
pulsed=0
pulsel=0
idlepulsing=1
idleled=0
omnisabers=0