fiduciary
Graflex Blue
Graflex Green
Graflex Purple
Graflex Red
Graflex White
Graflex Yellow
Home
Media
FAQ
Login
Register
FX-Sabers.com
»
The S.A.B.E.R. GUILD: Saber Manufacturers
»
Plecter Labs
»
CFX Neopixel Config
« previous
next »
Print
[
1
]
Go Down
Author
Topic: CFX Neopixel Config (Read 2944 times)
0 Members and 1 Guest are viewing this topic.
Darth Terminus
No Force
Posts: 15
Um...Hello?
CFX Neopixel Config
«
on:
October 02, 2019, 08:33:42 AM »
Hello!
My question is how do properly setup the config file for Neo Pixel.
I just built my first Saber and started testing it last evening. I am using CFX and a Neo Pixel 36 Inch blade I bought from Vaders Vault. I went into the config file on the SD Card and changed "ledstrip" from 0 to 120.
"plistrip" in the manual says "defines the number of pixels of the secondary ledstrip output". Does this refer to the second strip in the blade? And should I also change this from 0 to 120?
Any help would be appreciated as well as any other advice on configuration I may be missing.
Thank you.
Logged
(1 person liked this)
erv
Plecter Labs Inc. "Keeper of the Buttered Toast"
Manufacturer
Master Force User
Posts: 4920
Formerly known as Irvin PLECTER
Re: CFX Neopixel Config
«
Reply #1 on:
October 02, 2019, 08:43:54 AM »
Auxiliary pli strip out not enabled yet, no value needed for now
120 on ledstrip is enough to enable ledstrip mode
Logged
Props Electronics ?
Darth Terminus
No Force
Posts: 15
Um...Hello?
Re: CFX Neopixel Config
«
Reply #2 on:
October 02, 2019, 08:54:40 AM »
Thank you very much!
Logged
OwenSkywalker
No Force
Posts: 8
Um...Hello?
Re: CFX Neopixel Config
«
Reply #3 on:
December 01, 2019, 11:26:13 AM »
Hey all, I've also been researching this lately as I wait for my first neopixel saber build to come in. So there's 120 LED's in a VV 36" blade then? I actually haven't been able to find that little bit of info yet.
Logged
Print
[
1
]
Go Up
« previous
next »
FX-Sabers.com
»
The S.A.B.E.R. GUILD: Saber Manufacturers
»
Plecter Labs
»
CFX Neopixel Config
retrousse