Question,
I broke my buttons (used super glue on the plungers and it soaked all around and ruined the buttons), so I've been doing my testing using serial monitor and I have disconnected the physical buttons. I have my fonts loaded, and they seem to be working correctly, but I have a couple issues and I'm not sure if it's just using Serial Monitor that is the problem, or something else.
1) Verify - Upload - Open Serial Monitor -- sometimes first LED is lit green, no sound, nothing else on.
2) Using either "on" or "pow", ignites the saber, blade lights up, out sound and hum starts
3) Using either "off" or "pow", this turns the blade off, but most of the time with the following issues:
-- The very first pixel stays lit, sometimes green, sometimes blue, sometimes off.
-- hum does not turn off
If I power on, and power off a couple times, the first pixel will turn off
The only way to get hum to turn off, is to press the "aux" button (or rather type the command).
I have also clipped off 3 LEDS from my my 144 LED strip. I have set both spots that I can find with 141 from 144:
{ 10000, WS2811BladePtr<141, WS2811_ACTUALLY_800kHz | WS2811_GRB>(), CONFIGARRAY(presets) },
const unsigned int maxLedsPerStrip = 141;
Any thoughts? I'm working on getting my physical buttons replaced, but until I'll keep plugging away.