fiduciary

Author Topic: Fornax: MHS based Prizm saber with lots of brass  (Read 3691 times)

0 Members and 1 Guest are viewing this topic.

Offline Morannon

  • Force User
  • ***
  • Posts: 171
  • “Luminous beings are we…not this crude matter.”
Re: Fornax: MHS based Prizm saber with lots of brass
« Reply #15 on: August 15, 2018, 04:28:57 PM »
That brass is killer. Great idea.

Rebellion Run Jacen Solo
GCS Ascend

Offline SciFiSurfer

  • No Force
  • *
  • Posts: 29
  • .....negotiations with a light saber...
Re: Fornax: MHS based Prizm saber with lots of brass
« Reply #16 on: August 24, 2018, 04:53:47 AM »
Absolutely brilliant! Love the way you went about the detailing. Very inspirational.

Offline Ridire Fíréan

  • Force User
  • ***
  • Posts: 105
  • Up&down&around the bend a Jedi's story never ends
Re: Fornax: MHS based Prizm saber with lots of brass
« Reply #17 on: November 03, 2018, 09:37:16 AM »
Hey @Darkmatter73  !  I would have delayed showing this badboy off and held on to it until next year's TCSS Challenge... this would get LOTS of votes!

Very fine execution on a very unique hilt!

Offline Kreyhn

  • No Force
  • *
  • Posts: 28
  • BZZSHZRRMMmmmmm...
Re: Fornax: MHS based Prizm saber with lots of brass
« Reply #18 on: December 27, 2018, 06:42:54 AM »
That looks fantastic! What did you use for the brass overlays? I've been wanting to do an MHS-based build with brass bits but I'm not sure where I can get brass tubes that will sleeve over the MHS parts without too much fuss (other than stripping the chrome off a sink tube, of course).

I ended up finding some raw-brass sink-tubes at Lowes, no chrome!  Although, I ended up sanding the outside down to get it pristine, too.  I didn't have to worry about stripping the chrome, but that would probably happen through my sanding process anyway.

 

retrousse