Prizm 5.1 wiring help

[Jediseth]

This is my second Prizm 5.1 install. My first one works great. This time around it’s not working and I’m wondering if I could get some help.

Everything is wired properly from what I can tell. I have two accent leds wired up in parallel and they work so I know I’m getting power from the recharge port and battery. I have an RGB led wired and going to the appropriate pads. It’s not lighting up and the speaker is not working because I get no boot sound. I tried two different speakers so nothing seems to be wrong with the speaker I would think. This isn’t my first Prizm and I’ve wired one before with success. Any ideas what could be wrong? Thanks!

[3251bimmer]

If you put your SD card from the working prizm into this one does it do anything? Maybe the SD card just needs formatting?

[erv]

without wiring pictures and board pictures it's hard to tell !
I would also wire the RICE to any serial terminal @115200 baud to see if the board speaks up

[Jediseth]

Thanks guys, ya I’m a dork. It took me 20 minutes to figure out I didn’t have the SD card in it’s slot.   Lol , I didn’t think to look under the board. I even checked all my pads with a loop to make sure nothing was bridged  with a wire going wonky.
  Walked away came back and had my duh moment.  Rookie mistake.

[erv]

Thanks guys, ya I’m a dork. It took me 20 minutes to figure out I didn’t have the SD card in it’s slot.   Lol , I didn’t think to look under the board. Rookie mistake.

it's fine, a handful of porgs die each time it happens 

[Jediseth]

Lol, thanks Erv.

[SaberSlucker]

Could somebody confirm me that the NOT pointed lines on my wiring diagramm are the ones with high current running through? Thanks!

[erv]

The 2 red going to the neopixel connector (from the battery +)  and the (B) and (C) ground return.
And the green (-) from the recharge port (as the ledstrip ground return will flow thru it)

[SaberSlucker]

Thanks!  Than my wires are all right.
Took 22 AWG just to be sure.