fiduciary

Author Topic: Prizm v4 Aux issue  (Read 1059 times)

0 Members and 1 Guest are viewing this topic.

Offline Samhain138

  • No Force
  • *
  • Posts: 2
  • Um...Hello?
Prizm v4 Aux issue
« on: November 11, 2017, 12:15:52 PM »
I'm new to using a prizm, but this sabers aux switch seems to spaz out only under certain settings.  It's a cross guard, the main blade is RRW and when I have it set to use the silver flash the aux goes nuts.  When I have it set to just use red it works fine and has a dark flash on clash.

I've reformatted the SD card and tried reinstalling the fonts and no luck.  I tried formatting it again and installing the base package and it just goes haywire across the board.


Offline Samhain138

  • No Force
  • *
  • Posts: 2
  • Um...Hello?
Re: Prizm v4 Aux issue
« Reply #1 on: November 11, 2017, 02:24:21 PM »
So I took the blades out and tried to see how that affected it and it seemed to stop.  Then I put them back in and its ok.  Is this maybe a problem from overcharging it or something?  I don't really know what to think.

Offline erv

  • Plecter Labs Inc. "Keeper of the Buttered Toast"
  • Manufacturer
  • Master Force User
  • *
  • Posts: 4920
  • Formerly known as Irvin PLECTER
    • Plecter Labs - Props Electronics
Re: Prizm v4 Aux issue
« Reply #2 on: November 11, 2017, 11:22:59 PM »
ensure you twist or braid your power lines separately from the switches lines. Twist the aux and act switches with a dedicated low power ground wire to shield it and avoid any induction effect from your LED

 

retrousse