FX-Sabers.com
Trade Federation - Buy/Sell/Trade => Misc Equipment => Topic started by: shef on September 16, 2020, 07:00:28 PM
-
I built a 7/8" 'plecterpixel' blade that is 35" long, 250 pixels (ledstrip=125). I used madcow's tutorial (https://www.thecustomsabershop.com/Pixel-Blades-C153.aspx) to build it. Neither the tip or the PCB adapter are glued to the blade tube.
Parts list:
Foam tube for 7/8" thin and 1" thick tubes V2
7/8" Thin Walled Pixel Blade Adapter
Blade Side Pixel PCB - Resistor Installed
SK6812 144 LED Pixel Strip (x2)
7/8" Thin walled Trans White PolyC 35" long
Looking to sell for what it cost to build $115.70US Price includes shipping in the continental US. I am selling because the hilt I was building it for (mpp2.5) takes a 1" blade, so I have no use for it.
(https://i.ibb.co/5MMspnQ/image0.jpg) (https://ibb.co/5MMspnQ)(https://i.ibb.co/wN77rMS/image1.jpg) (https://ibb.co/wN77rMS)