Hello,
I have got a custom Luxeon Tri Rebel regular Blue, regular Red, neutral White.
I read everywhere that red is too bright, but in my case it is the opposite.
In common sense the blue is brighter than red and so it does wash out my red led completely.
I have an 0.5Ohm 3W resistor on blue and a 1.5Ohm 5W resistor on red.
Those are recommended for the protection circuit, but as stated above, they are not helping with mixing.
Did I perhaps buy the wrong led setup?
I'm kinda sceptical about using high resistors because they reduce the brightness of my saber...
I'm asking for help because I don't feel like buying a whole range of resistors to test it out, it's a waste of money.
Or is there a better way of doing it without resistors?