FX-Sabers.com

The S.A.B.E.R. GUILD: Saber Manufacturers => Sith Planet => Topic started by: Rhool13 on September 02, 2017, 06:38:29 AM

Title: Tips for wiring/fitting k4 switch?
Post by: Rhool13 on September 02, 2017, 06:38:29 AM

I was struggling with fitting my k4 switch into the spot for it and gluing it into place with the transistors, does anyone have any tips on how to do this? The transistors aren't rounded for the clamp, so I have been trying to figure out how they fit.

Title: Re: Tips for wiring/fitting k4 switch?
Post by: 3251bimmer on September 04, 2017, 03:58:15 PM

What's the exact issue? Trying to get the actual tactile switches under the clamp? You may need to lightly file down the board the switches are attached to.

Title: Re: Tips for wiring/fitting k4 switch?
Post by: Rhool13 on September 06, 2017, 02:46:10 PM

I actually figured it out, using some super glue I was able to fit everything the way I had wanted. Thank you though!