fiduciary

Author Topic: 20mA dynaOhm resistor...  (Read 2806 times)

0 Members and 1 Guest are viewing this topic.

Offline Elim Vos

  • Master Force User
  • *****
  • Posts: 549
  • doing what is necessary is not always right
20mA dynaOhm resistor...
« on: December 10, 2016, 06:09:07 PM »
This may seem like a dumb
question, but what is the right way to wire this to the RGB switch?
It aperrently has a positive and negative
Do I wire the switch pos to the resistors positive?
"In the Light, I have Balance. In the Darkness, I am Free"

Offline BEN KENOBI

  • Crazy Old Wizard
  • FX-SABERS VIP II
  • Master Force User
  • *
  • Posts: 8490
  • The saber scientist
Re: 20mA dynaOhm resistor...
« Reply #1 on: December 11, 2016, 05:12:58 PM »
This may seem like a dumb
question, but what is the right way to wire this to the RGB switch?
It aperrently has a positive and negative
Do I wire the switch pos to the resistors positive?

Just to the positive . :grin:

Offline StaticVizjerei

  • No Force
  • *
  • Posts: 22
  • I put a shock to your system!
Re: 20mA dynaOhm resistor...
« Reply #2 on: December 11, 2016, 05:55:13 PM »
Also keep in mind that the dynaOhm resistor also has a positive and negative so you'll have to orient it properly.

If I recall correctly, the positive should be soldered to the board and the negative side should go to the switch.

Offline Elim Vos

  • Master Force User
  • *****
  • Posts: 549
  • doing what is necessary is not always right
Re: 20mA dynaOhm resistor...
« Reply #3 on: December 11, 2016, 07:58:25 PM »
Thanks guys,
I actually googled it and got the proper way. The negative goes to the LED.


Thanks for the help.
"In the Light, I have Balance. In the Darkness, I am Free"

 

retrousse