fiduciary

Recent Posts

Pages:  [1] 2 3 ... 10
1
Lightsabers / Re: FS: Spot in VV Derelict run
« Last post by mountainjedi on August 06, 2022, 11:02:37 AM »
It’s the game accurate weathering I believe!
2
Lightsabers / Re: FS: Spot in VV Derelict run
« Last post by GusManB on August 05, 2022, 01:58:32 AM »
What weathering option did you order?
3
Read and signed.
4
you're very welcome and I'm happy it works. I got a few OLEDs that need more time to boot up before you can actually talk to them. Like those morning with late coffee cups
5
Slowboot=200 did the job. Now the OLED works on every boot...

Thx, really thats support on an other level, absolutely fantastic...

Lars
6
The in and out frequency was only for demonstration. It happens even if i wait around 5 sec between every "action". Sometimes it works every few times like in the video some times i need 20 or more bootcycles. I'll try the slowboot later today and report back.

EDIT: one correlation i watched is that the accent LED, wired as multicolor LED to Channel 6,7,8 to mirror bladecolor, switches slowly between what i would describe as default bootcolor to bladecolor when oled comes on, and more fast when oled doesn't.

Thx,
Lars
7
your OLED might not have the time to reset properly based on how you put the kill key in and out. It can be also one of those slow oleds that need more time to wait until the power supply is stable, before you can try to detect it

you can use the serial command (only as a command from the serial terminal, not in the config) slowboot=200 to add 200ms of boot delay before trying to sense the OLED and to initialize it. This is a permanent settings that will remain afterwards (hence not in the config). You can revert at anytime to slowboot=10 (min value 10ms)
8
Good morning,

as mentioned in the title my oled display only works lets say at random. Solderjoints are checked good and if the display is up it works perfect, even while battle no faults what so ever.

A video showing the bootattempts can be found here:


Same behavior with default/shiped soundsfonts and with custom ones.

Any suggestions where to look at?

Best regards
Lars
9
I do have the latest firmware V10.0007f, poi=1, qon=300, qoff=0, twon=500,-90,90, twoff=-500,-90,90. I will have to check the switch voltage later. I do not have a multi meter  at this time.

I have a new Kill switch on order. Will see if my Kill switch is bad.
10
check if you have the newest twist on/off enabled in your profiles (latest fw)
check if quick ignite is on,
and finally, check your switch wiring and act and aux pads voltages which should be 3.3V when switch is released.
Pages:  [1] 2 3 ... 10
retrousse