FX-Sabers.com

The S.A.B.E.R. GUILD: Saber Manufacturers => FX-SABERS Graflex Armory & GraflexShop "GRAFLEX FX-SABERS" => Topic started by: OwenS59 on December 21, 2020, 10:17:52 AM

Title: Aux switch spring loaded plunger - part name and replacement source?
Post by: OwenS59 on December 21, 2020, 10:17:52 AM
First time poster/noob.  I managed to lose one of the spring-loaded plungers which are used to transfer presses of the graflex faux-circuit board to the momentary aux switch.  :cry:  I’ve kludged together a temporary fix using some parts on my workbench; however, I’d like to replace it with the proper plunger.

Two questions: 1) What is the proper part name for the spring-loaded plunger, and 2) is there a source for such a replacement part?

Thanks!
Title: Re: Aux switch spring loaded plunger - part name and replacement source?
Post by: scott on December 22, 2020, 06:10:20 PM
You need to post pictures. The graflex circuit board solutions that I have used do not use springs, just printed holders...the Anakin Ep2 uses plungers and springs.
Title: Re: Aux switch spring loaded plunger - part name and replacement source?
Post by: OwenS59 on December 23, 2020, 06:56:54 AM
You need to post pictures. The graflex circuit board solutions that I have used do not use springs, just printed holders...the Anakin Ep2 uses plungers and springs.

As requested, pictures. Thanks!



Title: Re: Aux switch spring loaded plunger - part name and replacement source?
Post by: K-2SO on December 23, 2020, 07:04:45 AM
If you’re using stuff from imgbb.com, you have to use the BBcode link.
Title: Re: Aux switch spring loaded plunger - part name and replacement source?
Post by: OwenS59 on December 23, 2020, 08:52:56 AM
If you’re using stuff from imgbb.com, you have to use the BBcode link.

Ok, corrected.  Thanks!