OK, since so many people have asked recently, I am going to go ahead and start an interest thread. I already had plans in the works for another run to be announced in a month or two, but I will postpone announcing that run and do the Lego saber run instead. The AwesomeSauce run will be starting next month after I wrap up the Rebellion Jacen Solo run and I typically will overlap runs to make sure all my machines are working as much as possible. For example, if I wrap up turning work on a particular run and I move it to the mill for second operation work, then why not run something else on the lathe while I am running the first job on the mill?
To refresh people's memories:
(size comparison with Graflex)
As before, the saber comes in at just about 7.5" long, 2.814" at the largest diameter and has a 1.5" diameter colored acrylic blade. The difference between the previous run attempt and this one - I will redesign the internals to make use of the Nano Biscotti and/or Crystal Shard soundboards and single Li-ion cell battery.
I do not have any prices or details yet. I have to dig intot he old files and rebuild the models to add the soundboard and speaker setup. But to get a rough estimate, an empty, no install hilt would probably still be in the $175-200 range I think. Install costs would obviously add to that cost.
Once I complete the redesign, I will post new renders of the models, prices and details of the proposed run. If I get enough confirmed interest posted to this thread, I will move forward withthe run and open up a deposit thread.
Again, no deposits are do right now. All I need is you to post if you are interested so I can begin to create the interest list.
1. Jango Fett
2. Ladyhawke
3. Nihilus
4. naigon
5. Sollus Vir
6. Iggy
7. Clark Kent
8. MH
9. MH
10. Wariwen
11. Wariwen
12. Rusty
13. Rusty
14. ScrimpyPIE
15. vvenom
16. Darth Monkey
17. Solan Starr
18. PitDroid
19. Obi-Wan Kenobi
20. Spyder
21. Kit Fisto
22. Ancient Jedi
23. Alex Gordon
24. tange99
25. IndustrialAction
26. EV-9D9
27. ag3nt4877
28.
29.
30.