Graflex disassembly Questions

[Ti-el_terall]

Thanks for the advice.

[Lan-Ed-Tul]

no problem my friend.  ive done 3 real graflexs over to 1 a EL and 2 a luxeon convert, and thats the fastes and easiest way to remove it.

[Anatim]

so, the kit is here, but the low profile switch doesn't fit in the graflex..
its to fat, to fit in the blade socket...
does somebody know, what i could do..?

[Luke S.]

this si new to me as yoda told me to ditch that blade holder assembly for his new one.  I believe the old one should have a recess in the holder and you will need to drill down the rivet under the red button and remove the little disk.  i think you will also need to grind down the button on the switch you purchased also.  again i am not to this stage yet but am going off what I rmember yoda telling me.  best to PM yoda for the best advice but i think this is the direction you need to go.

[Anatim]

hm...i'll try to rasp the switch a little bit
i hope that this help...

edit:  so, the low profile switch is damaged..
i used the other switch to complete the conversion
but the switch is now inside the hilt...i will search for another low profile switch in germany...
the "cyan" blade is more green as blue...
so i will buy a new blue led..