fiduciary

Author Topic: Question about the pcb connector and the pcb holder  (Read 574 times)

0 Members and 1 Guest are viewing this topic.

Offline NessKafetheYoungling

  • No Force
  • *
  • Posts: 3
  • Hello there
Question about the pcb connector and the pcb holder
« on: December 28, 2022, 04:10:22 AM »
Hey guys ,I don't know if it is the right place to ask but I recently bought a pcb connector and the holder for it and I don't really know how is it placed in the hilt , do you have photos to show me ?

Moreover when I put the pcb in the holder so it doesn't make a flat surface .



[nofollow]

[nofollow]
 
Never tell me the odds

Offline K-2SO

  • Killer Droid Extraordinaire
  • Administrator
  • Master Force User
  • *
  • Posts: 1273
  • Congratulations! You are being rescued.
Re: Question about the pcb connector and the pcb holder
« Reply #1 on: December 28, 2022, 05:42:06 AM »
That looks like the Neopixel holder that’s meant for the TCSS thin neck system. That’s the type of holder you would use for a thin neck Luke or Obi-Wan type saber.

It won’t be completely “flat” because the bumps (solder pads and the wires you attach to them) are meant to go down the hole that that part of the PCB would sit over.



I find your arguments vague and unconvincing.

Quiet! *Slap* And there’s a fresh one if you mouth off again.

 

retrousse