FX-Sabers.com

Outer Rim => General Discussions - SW => Topic started by: Blackbird on July 08, 2020, 09:19:55 AM

Title: Pogo connector
Post by: Blackbird on July 08, 2020, 09:19:55 AM

Just a general question with regards to
Pogo connector,
Are they all the same or are some better than others?
I ask as I’m planning on doing a diy install.
And don’t fancy having to pull it apart to replace a component that could have been a better component.

Title: Re: Pogo connector
Post by: jbkuma on July 08, 2020, 01:16:40 PM

It's impossible to say that they are "all" the same.  You will have to make sure whichever one in particular is compatible with whichever other components you use.

As far s quality, some will claim to be better than others, and some claim to have outlandish ratings.  If you buy from TCSS or someone on this forum you can have some certainty that their products will be up to the task. 

Title: Re: Pogo connector
Post by: Blackbird on July 09, 2020, 08:47:00 AM

Thanks for the response.

I was not sure if there was any difference between them.
Shtok one