I have a Prizm v5.5.
Current wiring setup:
Power from batt to board and tri-cree (R/R/W)
R/R (red/red) wired (each with resistor) wired to single high power led port
W(white) wired to separate port (with resistor)
3rd High-power led port not used
Gnd to charge port(gnd)
Charge port(gnd) to board
2 accent leds (thru a resistor) to accent pads and work fine.
1 - flashes when saber is activated
1 - flashes when kill key is removed
Board works fine.
Ignition switch and Aux switch work fine.
Tri-cree needs to be setup as currently all leds FOC.
Problem:
When I apply the kill key the accent led's glow dimly (they are getting just over 2 volts).
If I remove the main power to the board I am still getting voltage to the board.
The solder joints look clean.
I rewired the accent led, the power and gnd to the board.
The tri-cree(+) is wired directly to the battery.
Could I be getting voltage back feeding from the tri-cree connection into the board?