I'm finishing up a ProffieBoard v1.5 based build. Initially I had CLASH_THRESHOLD_G set to 1.0 which seemed to be what is shown in all the example config files. When I power this up and ignite the blade the clash event triggers rapidly over and over again and is worse when the audio track plays. I had to bump this value up to 3.5 to get this saber to operator normally (like my other Teensysaber v3 based builds). Is this normal? Could there be something wrong with the ProffieBoard or my build?
Also, I am interested in purchasing additional ProffieBoards but can't seem to find a seller that has them in stuck. Any recommendations where to buy a ProffieBoard right now?
It's pretty normal to have to increase the clash threshold, but 3.5 is pretty high. At that level, it may be difficult to trigger clashes.
The levels needed are can be reduced by putting small amounts of padding around the speaker and/or board. (Like even a layer of electrical tape can be enough sometimes.)
However, if 3.5 works well for you, then there is no need to do anything. :)