I have now opted to use the Shtok 12-pin pcb set available from KR Sabers to connect my Jedi Killer chassis,& I'm gonna be running the saber with a GHv3 board.My question is this:
The wiring diagrams for the connector supplied on the Saber Armory store are very clear as to what goes to what,at least for the Verso,CFX & Proffie,as shown:
Wiring from the GH won't be a problem as the manual is very clear to follow (thank you Frederic,I love this board!).
But- nowhere on the diagrams can I see how to wire for an accent LED.My power button is a blue illuminated one; so one of the 3.3v pads on the GH is where I start that off,with its associated GND pad also,but which pads on the connector would seem to be the right ones to use for these?Does it share common pads with anything else,or am I missing something obvious?
Any help would be greatly appreciated as always,folks.👍🏻