FX-Sabers.com

The S.A.B.E.R. GUILD: Saber Manufacturers => The CUSTOM SABER SHOP => Topic started by: darthgrant on September 10, 2017, 09:52:36 AM

Title: Bending blade material- thin wall tccs blades
Post by: darthgrant on September 10, 2017, 09:52:36 AM

So..... I'm needing to bend/shape a 1 in thin walled tccs blade.  Has anyone else done this?  Thoughts?

Title: Re: Bending blade material- thin wall tccs blades
Post by: livebyhonor on October 14, 2017, 08:20:43 PM

I have tried but with minimal success. Only thing I have tried though is heat with the heat gun. It's a very fine temperature line from bendable to burned and melted. Perhaps if you had a controlled temperature box to find that sweet spot. Another possibility may be a chemical that will soften Polly blades forva short time.