FX-Sabers.com
The S.A.B.E.R. GUILD: Saber Manufacturers => Sith Planet => Topic started by: DarthPO on November 06, 2019, 02:08:54 PM
-
Hi
I am a padawan to custom Sabers and had ordered a empty crossgaurd 2.0 however I have just figured out how to do the crystal but I’m quite confused how to assemble the other parts . For example the red wire on the out side. The instructions that came with it were pretty much useless to me for the crystal but I haven’t got anything else for the other stuff. How do I take it apart to install the wire or do I not need to?
Any help would be greatly appreciated
-
This may help
[WIP] Proffieboard Neopixel Crossguard w/ accuracy upgrades | The Rebel Armory (http://therebelarmory.com/thread/10805/proffieboard-neopixel-crossguard-accuracy-upgrades?fbclid=IwAR2-jKti_HlsCDyXyX8oVHqVo2osBvE43kehdx0homH_2gl1VrG3Ijx18Fg)
-
This may help
[WIP] Proffieboard Neopixel Crossguard w/ accuracy upgrades | The Rebel Armory (http://therebelarmory.com/thread/10805/proffieboard-neopixel-crossguard-accuracy-upgrades?fbclid=IwAR2-jKti_HlsCDyXyX8oVHqVo2osBvE43kehdx0homH_2gl1VrG3Ijx18Fg)
Thanks for the link. Will read it when i have time does it say how to remove the top part from the main body. As for some reason i cant figure it out.
-
There are 4 allen key set screws, 2 on each side, that must be removed. You can see the hex keys through the holes in the sides of the top of the emitter.
-
Thank you have managed to take it apart, one last thing was the holes the red wire goes though how do I keep them to stay in place as they seem to fall out? I am new to their type of stuff so apologies in advanced .