so i decided to redo my Graflex 2.0 with a new chassis so here is the progress so far
here is the chassis work so far still waiting on some more parts to finish the
http//:
this time around i decided to full desassemble the saber and drill a hold and a channel in the blade holder to i can put a blade in (last time i did not do this and the wires for the switch were straight though the hole of the switch housing and ran down the blade holder to there didnt allow for a blade to be installed
http//:
http//:
i also ordered a sweet 7/8th heat sink from KR-sabers/saberbay which is a huge improvement from the 1 inch heat sink i ground down to fit the 7/8th inch profile last time
http//:
thats it for now more to come soon!!