fiduciary

Author Topic: Hopping on the Graflex 2.0 build bandwagon  (Read 7451 times)

0 Members and 1 Guest are viewing this topic.

Offline Mewgen

  • Experienced Force User
  • ****
  • Posts: 284
Re: Hopping on the Graflex 2.0 build bandwagon
« Reply #15 on: March 19, 2016, 07:07:38 PM »
Not hijacking thread but question for you or anybody out there. When wiring up your NV3 did you take the leads from the port to the board directly with a second lead coming off (2wires in same +/- board hole) to the Cree and switch or did you splice the port wire to a single wire off the +/- board holes to the parts. I ask bc I tried the splice way and it won't light my Cree but if test port wires directly to Cree get lights. Ran out of time to see if board getting power or not through the splice.

B+ leads were run directly from the battery. Each die has its own B+ and ground lead.

Offline DarkSideTendencies

  • Force User
  • ***
  • Posts: 129
  • It's becoming an obsession...
Re: Hopping on the Graflex 2.0 build bandwagon
« Reply #16 on: March 20, 2016, 08:11:23 PM »
Thanks I finally figured it out.

Offline smaneesint

  • Force User
  • ***
  • Posts: 104
  • You can call me Gibson. That's my nickname. ;)
    • Facebook
Re: Hopping on the Graflex 2.0 build bandwagon
« Reply #17 on: March 29, 2016, 07:08:29 AM »
That's a pretty neat job indeed! Make me regret a bit for not ordering the Darth Ryo chassis in the first place. Can't wait for all my parts to arrive.  :grin:

Offline Padawan311

  • Force User
  • ***
  • Posts: 203
  • MTFBWY
Re: Hopping on the Graflex 2.0 build bandwagon
« Reply #18 on: April 02, 2016, 08:10:53 PM »
What resistors did you use for the BBW LED.

 

retrousse