Hello FX-Sabers community!
After a few (a lot) of mistakes, the Ahsoka Tano Rebels font, Fulcrum, is fixed and ready to install on your sabers!
Huge Thanks to those who were helping me through this process, especially MikeyX who tested the font for me after "debugging."
For any new font makers out there, make sure that your rate is 22050hz if you're opting it for a Plecter Labs board, make sure no sounds are repeating (copies), and remove ALL metadata when exporting! Putting that out there so no one makes the same mistakes I have!
Getting back to jedi business, here is the link to download "Fulcrum" on your Plecter Labs powered saber:
Dropbox - Fulcrum Thank you all so much for the support and don't hesitate to contact me for any reason regarding the font!