I have finished my first build with the CFX. I have a KR pixel strip 132 led configuration. I built a crystal chamber and use an illumicore crystal. everything works properly except for the crystal. I have checked all my wiring. I ran continuity checks on all the wiring. The data resistor is a 330ohm. I have continuity from the data resistor up to the LS2 output.
I bypassed the LS2 output as a test by running a jumper from the data resistor (including the resistor) to the LS1 output and the crystal illuminated as expected. Both LS1 and LS2 circuits are using all of the L-group returns.
I tried setting up LS2 using auxstrip = 1 and accentstrip = -1. Neither parameter worked.
I am assuming this is a configuration issue...
Thoughts?
Is there maybe a voltage limit that the LS2 output cuts out with? My battery was "Energy Critical" recharging now...
//CF-X Configuration
debug=0
logport=0
vol=50
menuvol=70
menugest=0
trackgest=0
fontgest=0
beep=40
muteb=0
muteoff=0
sleep=50000
deep=0
qkignite=0
orient=1
valsnd=0
switch=3
offp=0
offd=200
onp=0
ond=20
swing_flow=360
clash_flow=300
spin_flow=400
smooth_flow=1000
lockup=300
loop=1
shuffle=2
plilh=3400,4200
omnisabers=1000
bladepower=100
ledstrip=132
auxstrip=1
tridentstrip=0
accentstrip=0
dragstrip=20
strippower=1111
ls1_timings=350,700,24,1,3
ls2_timings=350,700,24,1,3