fiduciary

Author Topic: Tri Cree led amp Issue HELP MR Windu CFX conversion  (Read 390 times)

0 Members and 1 Guest are viewing this topic.

Offline Windu Beginner

  • No Force
  • *
  • Posts: 1
  • Um...Hello?
Tri Cree led amp Issue HELP MR Windu CFX conversion
« on: February 04, 2021, 07:47:11 AM »
I am new to the saber comunity, I am trying a crystal focus X conversion of a MR Windu, I am using the tri Cree RG Royal Blue from the Custom saber shop, I wired all the components and for now I am using a powerful power supply that simulates a 3,7 V battery with 5 Amps continuous discharge current, this power supply also tells you how much amps are the components using, but also if I use them all at 1023,1023,1023 on the board they are not consuming more than 1,6 amps (I wired them with right resistors to achieve the max voltage written on the custom saber shop page for each led) they should use more than 3 amps because just the 3 LEDs should use 3 amps at max voltage and max number in the color section of the board.

Could this be a wire issue, i did not think about using the right wires and maybe I used too small ones, thanks for the Help.

 

retrousse