Plecter Labs Peeps,
The short version. First saber build.
Wired, soldered, tested, working GREAT! Then in my lapse of judgement, I installed the battery into it's chassis, backwards. For all of about 5 seconds. Now, zero sound. LEDs, flash on clash all still working. A few posts I have found say I probably fried the amplifier.
Did I just ruin a brand new sound board?
Saber Specs:
2W 28mm Bass Speaker
Nano Biscotte Sound Module V4
12mm Anti Vandal Momentary Blue Ring Switch
B/B/W Cree XP-E2 CopperNova
18deg Tri-Rebel/Cree Star Lens
.47ohm .5w Resistor (On negative BLUE LED)
.47ohm .5w Resistor (On negative Blue LED)
.47ohm .5w Resistor (On negative Momentary Blue Ring Switch LED)
1ohm 5w Resistor (On negative WHITE LED)
28 gauge wire used throughout
Regards,
Jeff