Hi Everyone,
I have installed the new NBv4 in a Vader Saber.
Used Bench Test and Multi-meter...and installed resistors (red - 1.2ohm / 3 watt - White .47ohm / .5 Watt) - I installed a Solo's Hold Panasonic PCB protected battery (tested at 3.7 volts).
All wiring has been checked and double checked.
Here is the issue:
The 1st font starts, plays a brief part of the boot (Vader R1)...lights the Saber, and all swings and clashes work)...but...the speaker is crackling and is weak.
Then, I switch to the 2nd font, get a beep, red ignites, (no ignition sound) and no sound at all - effects work
same on the 3rd font.
I Have one momentary switch on the Saber...and the wiring is correct.
The Sab3er also has a 1.3mm Recharge port. I have that wired correctly too...voltage is getting to the Board properly.
I have absolutely NO idea what is going on here...and I am completely confused at this point.
Anyone with any help would be GREATLY appreciated!
Thanks,