FX-Sabers.com
The S.A.B.E.R. GUILD: Saber Manufacturers => Plecter Labs => Topic started by: JihoSSJ5 on June 06, 2021, 05:25:54 AM
-
Hey, does anyone know why my power switch isn't working all of a sudden...I did a voltage check and it's at 2.5. The aux switch is still at 3.3
-
Try removing the switch and check again. Test also the 2 3.3v regulated to ensure the board has proper power
-
Detached the entire board, tested the regualated pads, they are both 3.3V. Aux switch is still at 3.3V and still works, but power switch is at 2.5V...when I try to connect power nothing happens and the accelerometer starts to get hot. I think there might be a tiny bit of solder in it...
-
that would explain it, there's a short somewhere