fiduciary

Author Topic: Vader Black Series Conversion  (Read 4543 times)

0 Members and 1 Guest are viewing this topic.

Offline brthegreat117

  • Master Force User
  • *****
  • Posts: 569
Vader Black Series Conversion
« on: January 05, 2017, 01:24:24 PM »
Hey all. So I decided to also convert my Black Series Vader
      For right now this is just the disassembly and primary wiring
So first of all, remove the screws on the shroud


And then this screw, and another on the opposite side (same as this one)

Then remove this screw and disassemble the switch area

Like I did with my Luke, I marked with a sharpie a wire to differentiate
        I took this a step further and instead of desoldering the leads, I clipped them, and extended the wires

Now tuck it in
You will then be able to remove the innards. Just lside them out
Now to remove these two pins

     One of these pins is covered by the tape that adds detail to the saber
     I just peeled it back a bit and proceeded to tap out the pins with a punch

Now the blade should come out.

Disassemble the housing and you should be here

Exactly like the Luke, bridge what you see and add a wire to each lead
This one was a bit messier for me than the Luke. I tried to clean up the solder a bit, but I had no desoldering braid
    Hopefully it still works well


Next update will be the LED
Using a XPE-2 Deep Red Cree with a 2ohm 1 watt resistor
A 1" heatsink module from TCSS with an 8.7 degree lens
« Last Edit: January 07, 2017, 12:53:26 PM by brthegreat117 »

Offline brthegreat117

  • Master Force User
  • *****
  • Posts: 569
Re: Vader Black Series Conversion
« Reply #1 on: January 07, 2017, 12:53:40 PM »
Finished!
Little things to note
No need for a resistor, had an issue that was solved when I clipped the resistor off

The most annoying thing was that my 1" heatsink didn't fit anywhere, so I had to sand the blade holder to 1" so I could snuggly fit the LED module inside. No instead of being 7/8s, it's 1".
    I prefer 7/8s so I'll be making a 1" to 7/8s sleeve
    I should have just used the conversion kit, but this was pretty excruciatingly fun in a way
The Deep Red is so cooooool. Feels so Rogue One-ish especially down my hallway







Offline TheSaberCore

  • Force User
  • ***
  • Posts: 135
  • Every saber has a core.
Re: Vader Black Series Conversion
« Reply #2 on: January 07, 2017, 01:45:50 PM »
Thanks for this, thinking about maybe doing this myself. That deep red is gorgeous.
"Luke."

"The Belonging you seek is not behind you, it is ahead."


Offline brthegreat117

  • Master Force User
  • *****
  • Posts: 569
Re: Vader Black Series Conversion
« Reply #3 on: January 07, 2017, 02:19:11 PM »
Thank you! Hope it helps.
Get the conversion kit and don't be like me who had to struggle 30 min with sanding lol

After seeing this color, their is no other red for me. It just such a potent red/

 

retrousse