DM1 (Darth Maul Korbanth) 3D Printed kill key for Silver button

[Wolf69]

Hey Guys,

I have design a kill keyfor the DM1 (Darth Maul Korbanth) 3D Printed kill key for the Silver button.

Instructions:
You will have to drill and tap the hilt first for the recharge port. Then sand the bottom of the silver button in order for it to sit flush on the recharge port since you 'll have a nut securing it in the hilt, that way it will be at the same high as the red button.












Warning Depending of the version you have V1 (2016 and before) or the 2017 you will have to choose a different kill key!
The noticeable difference is the inner, if the ID is reduced to 7/8" on one paret, you have a V1.

Everything is my shapeways shop:
[url=https://www.shapeways.com/shops/wolf69-creation-s]Wolf69 Creations by wolf69 - Shapeways Shops

Hope it will help some of you in your build!

[Darth Jal]

I am interested in getting 2 of these. Let me know where to send pp.

[Wolf69]

They are available here:
Wolf69 DIY Solutions by wolf69 - Shapeways Shops

Cheers