Hello there!
I've wired up the following in series (data line) to the LS2 pad on the CFX - TCSS Pixel ring switch to 2nd TCSS pixel ring switch to 10 segment 3.5mm accent led strip to Schtok NPXL V3 hilt side PCB. The total number of LEDs in the string total 28, set accordingly in the config file. I'm using bmp images with the new Grafx pixel sequencer to drive the colors and patterns. The 2 switches and 10 segment led strip are working perfectly. However, the LEDs on the Schtok PCB are showing the correct color, but are barely lit and in a constant on state (should be blinking). The TCSS pixel switches both have a 330 ohm resistor installed in the switch, and the Schtok NPXL pcb is wired according the manual in V4 configuration (330 ohm resistor on the R2 pads, no resistor on R1, no jumper on D2). The main blade is working fine. Can anyone help? Is the 330 ohm resistor on the Schtok PCB too much for the incoming signal?
Thank you for any help you can provide.
P.S. I tried attaching the wiring diagram, but it won't let me, guess I'm too new. I can email the diagram or photos to someone if that will help. Thanks again.