FX-Sabers.com

The S.A.B.E.R. GUILD: Saber Manufacturers => The CUSTOM SABER SHOP => Topic started by: NessKafetheYoungling on December 28, 2022, 04:10:22 AM

Title: Question about the pcb connector and the pcb holder
Post by: NessKafetheYoungling on December 28, 2022, 04:10:22 AM
Hey guys ,I don't know if it is the right place to ask but I recently bought a pcb connector and the holder for it and I don't really know how is it placed in the hilt , do you have photos to show me ?

Moreover when I put the pcb in the holder so it doesn't make a flat surface .



(https://i.ibb.co/c3pcfff/IMG-20221228-125836.jpg) (https://ibb.co/c3pcfff)

(https://i.ibb.co/qxrgCqd/IMG-20221228-130038.jpg) (https://ibb.co/qxrgCqd)
 
Title: Re: Question about the pcb connector and the pcb holder
Post by: K-2SO on December 28, 2022, 05:42:06 AM
That looks like the Neopixel holder that’s meant for the TCSS thin neck system. That’s the type of holder you would use for a thin neck Luke or Obi-Wan type saber.

It won’t be completely “flat” because the bumps (solder pads and the wires you attach to them) are meant to go down the hole that that part of the PCB would sit over.