It's very bright. The original Safety plug I had intended for this one didn't work, since it allows a good deal of light though it. I had to use one of our Obi-Style Plugs.
The mirror finish was accomplished by sanding the MHS peices down, starting at 400 grit and gradually working up to 3000 grit wet paper. Took about an hour to do it, but it was worth it, I think.
This was Kyuubi's original design:
I hope we did it justice. ;)
And here is a "naked" shot of the MHS pieces before they were PC'd. And a comparison shot to unpolished MHS pieces.
Kyuubi, Thank you for letting us do this and I hope you enjoy it. As always, we'll keep it around for a few days to make sure there are no issues... and then it's off to your house.
Thanks again!
Casey (MJ)