I had a previous issue with a dislodged contact pad on my CFv6 board (one of the R.I.C.E. contacts), the pad came off during desolding, leaving only a tiny bit of trace.
I was advised to use a thin piece of bare wire from a resistor to repair it. The repair worked and the solder held, but it is a weak connection and is prone to coming undone. I was wondering if, after reattaching it, I can use a dot of hot glue as added support. Or if there is any other kind of adhesive which can lend vibration support to this weak joint (I've read about neutral cure silicone rubber).
Any help would be greatly appreciated.