Thanks everyone...I appreciate the comments.
Nice Crystal chamber details.
Looks like I need to consider getting a rotary table and indexer for my mill.
Yes...yes you do :) . I love the things I have been able to do with mine. My old small mill (small table top model) didn't have one but the new (to me) mill came with two. One small one and one giant one that I can fit MHS parts through the center. The giant one is the only one I have used so far...
here are a couple pics of it
I decided I didnt like the top part of the crystal mount so I decided to change it up a little bit. Make it more compact and fill in the center section. Originally I left that open because I was going to use a second crystal but decided not to and use a different top.
Old on right new on left. It still need to be cleaned up along with the rest of the parts (a little time in a tumbler) but you can see the design anyway.
Also I really like the lower more compact angle (60 degrees vs 30) and think I will change the bottom mount to have that same angle. That gives me more room for the crystal too which kind of bugged me before.