Guys, yes the shortage has been going on since last year. I am not sure if you watch the news but it has been bad. I will not get into all I have had to do to get parts to make boards because it involves other companies but it has been very difficult to get parts...I can't use parts that were purchased by or for other companies. Nobody has walked back a single thing. I thought I was going to be able to send them back then because I thought I had a line on parts then but it didnt work out. I was willing to pay over $20 for one single component but it fell through.
This run has been frustrating I know to everyone involved and it has seemed like one thing after the other has come up but they should be going to the installers next week and hopefully put an end to this nightmare.
I realize my absence is troubling but I just do not have the time to come on here much. I have told people a few times to email OR PM me with questions but I got neither.
I have the parts to finish enough boards now and will be doing so this weekend so that I can send the sabers to the installers.
Here is a pic for everyone.
https://mandysbabies.com/obi/obiready1.jpgJoker, yes they will be completed but I understand the concern. I have been honest with everyone from the start. The biggest thing was the anodizing...I wish I had just had them machined where I could have powder coated them now. I didnt realize so few places would do a glossy black anodizing. I should have done more research on it before I started the run.