fiduciary

Author Topic: Turning on power, Blade Ignite and Close sounds loop over and over  (Read 150 times)

0 Members and 1 Guest are viewing this topic.

Offline Darth Terminus

  • No Force
  • *
  • Posts: 15
  • Um...Hello?
Hello,

This does not happen every time. But it is happening about 50% of the time. With the Chassis out of the saber, no buttons being pressed, on flipping the kill switch to on, the saber will play the current sound font intro, After that completes the Ignite and Blade off sounds play back to back over and over. I cut all the cables off the Primary and aux switches and tested it, and it still does this. Any idea at all what could be causing this?

Everything works perfectly when the saber boots normally.

Thank you

Offline erv

  • Plecter Labs Inc. "Keeper of the Buttered Toast"
  • Manufacturer
  • Master Force User
  • *
  • Posts: 4870
  • Formerly known as Irvin PLECTER
    • Plecter Labs - Props Electronics
Re: Turning on power, Blade Ignite and Close sounds loop over and over
« Reply #1 on: July 30, 2022, 11:02:25 PM »
check if you have the newest twist on/off enabled in your profiles (latest fw)
check if quick ignite is on,
and finally, check your switch wiring and act and aux pads voltages which should be 3.3V when switch is released.

Offline Darth Terminus

  • No Force
  • *
  • Posts: 15
  • Um...Hello?
Re: Turning on power, Blade Ignite and Close sounds loop over and over
« Reply #2 on: July 31, 2022, 03:13:29 PM »
I do have the latest firmware V10.0007f, poi=1, qon=300, qoff=0, twon=500,-90,90, twoff=-500,-90,90. I will have to check the switch voltage later. I do not have a multi meter  at this time.

I have a new Kill switch on order. Will see if my Kill switch is bad.
« Last Edit: July 31, 2022, 03:16:41 PM by Darth Terminus »

Offline Darth Terminus

  • No Force
  • *
  • Posts: 15
  • Um...Hello?
This has been resolved with a new kill switch

Offline erv

  • Plecter Labs Inc. "Keeper of the Buttered Toast"
  • Manufacturer
  • Master Force User
  • *
  • Posts: 4870
  • Formerly known as Irvin PLECTER
    • Plecter Labs - Props Electronics
Re: Turning on power, Blade Ignite and Close sounds loop over and over
« Reply #4 on: August 14, 2022, 02:28:01 AM »
Awesome 👍

 

retrousse