FX-Sabers.com
The S.A.B.E.R. GUILD: Saber Manufacturers => Plecter Labs => Sound boards technical issues / questions / problems => Topic started by: Darth Terminus on July 30, 2022, 06:52:54 PM
-
Hello,
This does not happen every time. But it is happening about 50% of the time. With the Chassis out of the saber, no buttons being pressed, on flipping the kill switch to on, the saber will play the current sound font intro, After that completes the Ignite and Blade off sounds play back to back over and over. I cut all the cables off the Primary and aux switches and tested it, and it still does this. Any idea at all what could be causing this?
Everything works perfectly when the saber boots normally.
Thank you
-
check if you have the newest twist on/off enabled in your profiles (latest fw)
check if quick ignite is on,
and finally, check your switch wiring and act and aux pads voltages which should be 3.3V when switch is released.
-
I do have the latest firmware V10.0007f, poi=1, qon=300, qoff=0, twon=500,-90,90, twoff=-500,-90,90. I will have to check the switch voltage later. I do not have a multi meter at this time.
I have a new Kill switch on order. Will see if my Kill switch is bad.
-
This has been resolved with a new kill switch
-
Awesome 👍